For UAE project teams, the key is to match this exact configuration to the port schedule, optical budget and delivery documentation. This custom fiber patch cable is built to the precise setup the project specifies: connector styles, polish, fiber mode, jacket and length are all chosen at order time and this assembly is factory terminated and optically tested before dispatch.

Product Highlights

• G.657.A1 Bend Insensitive Fiber Delivers Superior Low Loss and Bend Resistance
• Precision Zirconia Ferrule Connectors Ensure Low Loss
• Duplex Zipcord Construction Reduces Risk of Damage from Crimping
• Available in LC, SC, FC, ST, LSH, MU, and MTRJ Connectors
• Available in 1.2mm, 1.8mm, 2.0mm, and 3.0mm Cable Diameters

Specifications

Built to the order

The custom program covers the combinations that stock lists cannot: mixed connector families, non-standard jackets, unusual lengths, identification and packing to the project specification. This assembly is terminated and tested exactly like a stock product, with the setup confirmed prior to production.

Where single-mode jumpers earn their place

Single-mode patching carries the links that leave the room: campus backbones, carrier handoffs, long runs between buildings and each wavelength-multiplexed service. The OS2 glass in the assembly is the identical group used in the outside plant, so this jumper does not become the weak point of the optical budget. At 1310 and 1550nm the attenuation stays a fraction of a decibel per kilometer, and this connector pair adds less than 0.3dB when the end faces are clean and seated.

Connector and polish choices in the single-mode plant

The OS2 interface on this jumper follows the polish discipline of the network it serves. Mixing polishes on a mated pair destroys the return loss and may damage the ferrules, so the patch side must be matched to this panel side exactly. When the documentation is unclear, the boot color and this connector housing tell the truth: green for APC, blue or beige for UPC.

Length Options

Standard length options cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), with custom length offered beyond the list. Specifying the measured path length keeps the slack out of the manager and the strain off these connectors.

Quality Control and Testing

Each assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. This cable ships with dust caps on the two connectors and the test result offered on specify.

Ordering and Factory Support

Refer to this setup by connector pair, fiber mode and length when ordering a quotation. For configurations outside the listed options, mixed connector families, jackets, identification or project packing, send the need with the inquiry and the factory will verify the build prior to production. Our UAE project support can review the requirement with Shenzhen production before a formal quotation is issued.