For UAE project teams, the key is to match this exact configuration to the port schedule, optical budget and delivery documentation. This OM3 fiber patch cable carries a LC UPC interface on one end and a LC UPC interface on the other, factory terminated on OM3 glass and optically tested as an entire unit. The uniboot build places the two fibers of the duplex connection inside a single round 2.0mm cord with one combined connector housing, halving this cable count in high-density panels and simplifying polarity management.

Product Highlights

• Uniboot Allows One Cable to Carry Two Fibers to Reduce Cable Congestion in High-Density Patch Fields
• Bend Insensitive Fiber with 7.5mm Min. Bend Radius
• Termination Is Tested to Ensure Network Performance
• Designed for High-Density Fiber Cabling in Network Cabinet Connections, Ceiling Wiring and Under-Floor Wiring in a Data Center
• Support for Various Transmission Speed Ethernet Applications

Specifications

Keeping multimode links healthy

Multimode links fail more frequently from contamination than from fiber damage. Each ferrule should be inspected and cleaned before connection, and the dust caps ought to stay on until the moment of interface. These habits matter more than any specification on the datasheet.

OM3 for existing multimode plants

This OM3 unit matches the existing base of OM3 link cabling: 10G links to 300 meters and 40/100G SR4 links to 70 meters. When the permanent connection is OM3, patching with OM3 keeps the link specification homogeneous and the test reports clean.

Polarity without re-terminating

Uniboot connectors expose the polarity through the housing rather than the termination: the latches or clips let the installer swap the fiber positions without opening the cord. A polarity mistake discovered at turn-up becomes a two-minute correction instead of a replacement order. For UAE procurement, record this requirement with the project documents so the supplied configuration can be checked on arrival.

Length Options

Standard length options cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), with custom length offered beyond the list. Specifying the measured path length keeps the slack out of the manager and the strain off these connectors.

Quality Control and Testing

Each assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. This cable ships with dust caps on the two connectors and the test result offered on specify.

Ordering and Factory Support

Refer to this setup by connector pair, fiber mode and length when ordering a quotation. For configurations outside the listed options, mixed connector families, jackets, identification or project packing, send the need with the inquiry and the factory will verify the build prior to production. Our UAE project support can review the requirement with Shenzhen production before a formal quotation is issued.