For UAE project teams, the key is to match this exact configuration to the port schedule, optical budget and delivery documentation. This OS2 fiber patch cable carries a SN UPC interface on one end and a LC UPC interface on the other, factory terminated on OS2 glass and optically tested as an entire unit. The uniboot build places the two fibers of the duplex connection inside a single round 2.0mm cord with one combined connector housing, halving this cable count in high-density panels and simplifying polarity management.

Product Highlights

• Uniboot Allows One Cable to Carry Two Fibers to Reduce the Cable Bulk When Routing
• G.657.A1 & 10mm Min. Bend Radius
• Very Small Form Factor (VSFF) Connector, 3x Fiber Cabling Density over Duplex LC
• Push-pull Boot Allows Quick Plug without Tools in High-density Space
• Reverse Polarity without Exposing the Fibers or Needing Any Tools Support for 100/400/800G Ethernet Communication

Specifications

Where single-mode jumpers earn their place

Single-mode patching carries the links that leave the room: campus backbones, carrier handoffs, long runs between buildings and each wavelength-multiplexed service. The OS2 glass in the assembly is the identical group used in the outside plant, so this jumper does not become the weak point of the optical budget. At 1310 and 1550nm the attenuation stays a fraction of a decibel per kilometer, and this connector pair adds less than 0.3dB when the end faces are clean and seated.

Connector and polish choices in the single-mode plant

The OS2 interface on this jumper follows the polish discipline of the network it serves. Mixing polishes on a mated pair destroys the return loss and may damage the ferrules, so the patch side must be matched to this panel side exactly. When the documentation is unclear, the boot color and this connector housing tell the truth: green for APC, blue or beige for UPC.

Polarity without re-terminating

Uniboot connectors expose the polarity through the housing rather than the termination: the latches or clips let the installer swap the fiber positions without opening the cord. A polarity mistake discovered at turn-up becomes a two-minute correction instead of a replacement order. For UAE procurement, record this requirement with the project documents so the supplied configuration can be checked on arrival.

Length Options

Standard length options cover the common patching routes: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), with custom length offered beyond the list. Specifying the measured path length keeps the slack out of the manager and the strain off these connectors.

Quality Control and Testing

Each assembly is terminated with precision zirconia ferrule connectors and optically tested before packing: insertion loss and return loss are verified on every cable, and end-face geometry is inspected for consistent physical contact. This cable ships with dust caps on the two connectors and the test result offered on specify.

Ordering and Factory Support

Refer to this setup by connector pair, fiber mode and length when ordering a quotation. For configurations outside the listed options, mixed connector families, jackets, identification or project packing, send the need with the inquiry and the factory will verify the build prior to production. Our UAE project support can review the requirement with Shenzhen production before a formal quotation is issued.