Our MTP® Elite Female/Male with Offset Key harness cable gives you a direct MTP to LC duplex connection without any intermediate hardware. 16 Fibers (Base-16) on OS2 9/125μm fiber with Plenum (OFNP)/LSZH jacket, with each LC leg labeled for fast port mapping.

Available lengths are 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 10m (33ft), 15m (49ft), 20m (66ft), 25m (82ft) and 30m (98ft). We can also produce any intermediate or longer length to order, with your choice of labeling and packaging.

Product Highlights

• MTP® Elite Female/Male with Offset Key to LC/SC/FC/ST, 16 Fibers (Base-16)
• OS2 9/125μm, G.657.A1
• Insertion loss ≤0.35dB, return loss ≥60dB
• Straight Through/Crossover polarity
• Plenum (OFNP)/LSZH
• Minimum bend radius 10mm
• Stock lengths from 1m (3ft) to 30m (98ft), custom lengths on request

Where a cassette would normally convert MPO to LC, this harness does the same job in one piece. The 16-fiber interface matches 400G SR8 optics, where all 16 fibers carry active transmit and receive lanes. Fewer mated pairs means better loss budget and fewer failure points.

Every LC duplex leg is factory polished and tested individually, with return loss well above the multimode or single mode requirement. The fan-out is compact and strain relieved, and the leg numbering matches the polarity table for error-free patching.

To order, quote 16FMTPXXSMF together with the length and quantity you need. Private labeling, custom packaging and project specific documentation are all handled in-house.

Each assembly is coiled, capped and sealed in an individual bag, then packed into foam lined export cartons. Test reports can be attached per unit or per batch, and carton marks follow your shipping instructions.

We have manufactured fiber optic assemblies since 1995. MPO and MTP cabling is one of our core lines: fiber counts from 8 to 144, single mode and multimode, UPC and APC polish, trunk, jumper, harness and breakout formats. Send your drawing and we turn it into a ready to install assembly.

Our test routine covers insertion loss, return loss and ferrule end face inspection on every assembly. Because testing is done in-house, custom variants receive exactly the same verification as standard models.